These instructions are for both the Ride On & Ride On Colossus penis extensions. How to best put on the Ride On Use approximately a quarter's diameter size amount of water-based lubricant (NOT silicone) divided between the inside of the Ride On and your penis. Too much lubricant will eliminate the friction that helps your penis and the Ride On move as one and can make the penis slip out during use. We recommend you practice putting it on once before trying with a partner, this will allow you to fine tune the procedure. With one hand squeeze the Ride On, eliminating the air inside. With your other hand push the head of the penis in the opening and slowly release the pressure on the Ride On from the bottom up. This is accomplished by releasing the pinkie, then ring finger, middle finger then pointer. The action will pull your penis into place. Roll the sleeve down to the base of your body. Take the testicle ring and pull your scrotum through the ring as far as possible where the testicles touch the Ride On but are not through. Then pull the ring with your left hand to the left and push through that testicle. Repeat on the other side. Please do not attempt to stretch the ring, it is designed to be flexible for comfort but attempting to stretch around the testicles may cause it to break. If your penis is not firmly held when using, reduce the amount of lubricant on the inside. Once you start to use the Ride On with a partner, use plenty of lube on the outside. This will make it more comfortable for your partner and also reduce the chance of internal slippage of your penis. Quick Guide |